HEAT RESISTANT glue for chimneys and stoves

Special heat resistant glue on the base of fire-resistant mineral fillers and modified additives intended for ovens and fireplaces, bricklaying and repairing chimneys. Plastic mass that is easy to apply and even over the surface.

FEATURES:

• Product ready for use;
  
• Simple use;
  
• High temperature resistance up to 350°С;
  
• Small consumption.
  

USAGE: Before applying glue the surface must be accurately purified from the old paint, glue, plaster, dust, friable layer as well as seams should be purified. For gluing poorly absorbing surface, it is recommended to perform 2-3 mm deep notches on gluing surface as well as using temperature resistant primer in order to improve adhesion to surface. Well absorbing surfaces should be beforehand moistened with water. Friable and poorly structured surfaces are recommended to strengthen using temperature resistant primer. Seams’ filling should be performed after 24-48 hours using temperature resistant seams’ filling mass. It is not recommended to use the glue on heated or plastered surface. Possible a partial thickening of product, with mixing, will get a working consistency.

CONSUMPTION: Approximately 1l/2-3m², if the thickness layer is 2-5mm. 

DRYING: Primary glue bond time 30-50min. Final solidification within 24-48 hours, surface absorbing ability, environmental temperature and the thickness of the applied layer. Processed surface can be exposed to high temperatures after 10-15 days.

STORAGE: In original package, at temperature above 0ºC stored approximately for – see the label. May not freeze. Mix well before use.